9. Turn the body of the bicycle
10. Installing an additional wheel
Nut A
First unscrew the
nut from the rear
wheel axle, install
the additional wheel,
guided by the image in
the picture.
11. Installation of V-shaped brakes
Adjust the V-shaped brakes according to the image or scan the QR code to view
the detailed video of installing and assembling the bicycle.
12. Fine adjustment of a brake rope
Adjusting the
nut
Adjusting the
screw
Precise adjustment of the
nut and screw from the initial
state
Synchronously rotate the screw
and nut to 2-3mm, as shown in
the figure.
When the adjustment is
complete, rotate the screw and
nut in the opposite direction until
the initial state.
13. Adjusting the brake lever
Adjusting cross-head
screwdriver
If the amplitude of the back stroke of the left
lever is small, tighten the screw more, using
a cross-head screwdriver, as in the figure.
Increase the stability of the left brake lever
spring.
At the same time, you can loosen the adjusting screw of the right brake lever, reduce
the stability of the right spring.
In accordance with the above actions, the amplitude of the back stroke of the left and
right arms should be approximately the same.
14. Adjustment of the tilt of the bell
Adjust the slope of the
bell according to the
picture in the picture,
tighten the bottom cross
screw.
15. Setting the right pedal
R mark - right pedal
Clockwise
07
08
