Controls
5
INPUTS (RCA)
These inputs are connectd to the source unit’s outputs.
6
2ch/4ch Switch
This control is used to select how many inputs the amplifier uses, two or four inputs.
7
Input Level Switch
This control is used to select High (Speaker) or Low (Line) level inputs.
8
GAIN
This control is used to match the amplifier’s input sensitivity to the source unit’s output.
9
PRE OUT
This is a Line level stereo output to provide signal to additional amplifiers .
10
X-OVER SWITCH
This switch is used to select the filter for the respective amplifier channels, Low Pass (LPF)/ Band
Pass (BPF), Fullrange (FULL) or High Pass (HPF).
11
AUTO TURN ON
When the amp is switched to accept High level inputs, this switch is used to select if the amplifier
needs to switch on/off via remote input signal (Rem) or via Auto Sensing (DC Offset and Audio)
12
HIGH PASS FREQ.
This control is used to set the High Pass filter frequency for the speaker outputs.
13
LOW PASS FREQ.
This control is used to set the Low Pass filter frequency for the speaker outputs.
14
POWER & PROTECTION LEDS
The Power LED shows if the amplifier is ON (LED is green- or blue-lit), the protection
LED shows if the amplifier is in protection (LED is red-lit).
EFX series
LIFE AMPLIFIED
