XFactory X - 6 SQUARED, Инструкция по эксплуатации, Страница: 8 / 8

K021 Instructions v1.0 Bag I Page 69
I16) Cut out the wing; check the Tuning
Section to determine what the
various cut lines will do on the
track. Cut two holes a bit less than
1/4” (5 mm) diameter on either set
of dimple marks. The Tuning
Section and Set-Up sheet will tell
you which set of holes to use. Use
the two black nylon wing washers
(6311) and body clips (6310) to
attach the wing to the wing mounts.
I15) Install the wheels and tires (not included). The rear wheel nuts are on the axles;
the front wheel bearings (3/16” X 3/8” rubber sealed 6200) and 1/4” button head
screws (6041) should be the last parts from Bag I.
Here is the beautiful X – 6 Squared of Team driver Yuichi Ajishi-san. Dialed!
Now, go through Paul’s Final Set-Up & Prep section, then
completely confuse yourself in the Tuning Section, and
LET’S GO RACING!!!