10
longitudeE/W,latitudeN/S to unit to set the restricted district. In case of breach, it will
send SMS “stgeo-info” to the authorized numbers.
Remark : The first latitude&longitude is coordinate of the top left corner of the
Geo-fence, while the second latitude&longitude is the coordinate of the bottom right
corner. It will alarm one time in each setting.
5.11.2 Cancel: Send SMS nospassword to deactivate this function.
This function will be out of effect after the unit moves outside the district.
5.12 Movement alert
5.12.1 Set up: When the unit stays immobile in a place for 3-10 minutes, the user can
send SMS move+password to the unit, then the unit will reply “move ok!”. In case of
such a movement, it will send SMS “Move” along with a Geo-info to the authorized
numbers. It will alarm one time in each setting.
5.12.2 Cancel: Send SMS password to deactivate the movement alert.
Remark: This function will be out of effect after the unit moves outside the district.
5.13 Overspeed alert:
5.13.1 Set up: Send SMS speed+pspace+080 to the unit (suppose the speed
is 80km/h), and it will reply “speed ok!”. When the target moves exceeding 80 km/h, the
unit will send SMS speed+080!+Geo-info to the authorized numbers. It will alarm one
time in each setting.
5.13.2 Cancel: Send SMS password to deactivate the overspeed alert
Remark: It is recommended that the speed alarm is set at not less than 50km/h. For
below that rate, it may cause the excursion of the GPS signal influenced by clounds etc.
