Xeuss Tike, Руководство пользователя

Страница: 8 / 27

8
y In order to minimize power consumption for optimal performance,
please note the following provisions: Do not hand cover the phone
antenna site, or it may affect call quality, and cause the phone to the
normal level of output power beyond the work, shorten the Battery
talk time and standby time.
RF energy
y Your cell phone is a low-power radio transmitter and receiver. Once
the boot, it will intermittently receive and transmit radio signals.
Network system will control the phone's transmitting power.
2. GETTING STARTED
2.1.
Battery
Set box with battery, battery not charging when the purchase, but
there may be support boot.
The new battery is completely used up, please boot state without
charge at least 12 hours, so after three consecutive charge and
discharge, the battery will achieve the best use of the state.
2.1.1.
Battery removal and installation
Demolition of the battery set the back of the phone facing you,
press and hold the battery cover the top, sliding down the back cover,
you can remove the battery located at the bottom to pull the hand out
flip, and you can remove the battery.
Installation, insert the battery the edge of the corresponding slot, slot,
press the battery down, then cover the back cover, you can install a
good battery. Please be sure that the phone battery before booting.
2.1.2.
Battery charge
Please phone charger connector into the charger jack, and charger
plugged in, it will start charging.
Flashing battery symbol that is charging, when charging symbol
stationary, that is fully charged.
During charging, batteries, cell phone and charger become hot, this
is normal, charging is completed, please turn the power off, unplug the
charger.
Warning
：
¾
provides charging temperature range 0
℃
-50
℃
, over this range,
please do not use the charging equipment.
¾ Be sure to use the charger provided by the supplier, the use of an
unapproved charger may be dangerous and breach of the phone
recognition and warranty.
2.1.3.
Battery
Providing handset manufacturer’s standby time and talk time is an
ideal work environment based on the value, the actual use state, battery
life may be with the network conditions, work environment and the use
of different methods vary.
Dispose of batteries according to local regulations (erg recycling),
Do not dispose as household waste.
2.1.4.
Power of direction
Cell phone turned on, battery power level displayed in the upper
right corner of the screen
2.2.
Connect to the network
2.2.1. SIM
Your network operator for your mobile phone to provide a plug-in
user identification card, which is SIM card .
SIM card is your key to enter the digital GSM network, access to the
network start communications; you must first insert a valid SIM phone
card.
And a network connection of all relevant information, are recorded
in the SIM card in any future name, phone numbers and information, will
also be stored in SIM card.