Quick Network Setup (Static IP)
3
Quick Network Setup (Static IP)
Prerequisites for Manual Setup of Network Using Static IP Address
Note
On startup, the WorkCentre multifunction machine defaults to DHCP to obtain its
network configurations, so DHCP must be turned off by manually entering a static IP
address.
Before installing, record the following information for use during setup:
Note
To obtain this information, contact your System Administrator.
Procedure for Manual Setup of Network Using Static IP Address
1.
Power on the machine.
2.
Press the <Log In/Out> button on the control panel, and then type the System
Administrator login ID
to enter the System Administration mode.
Note
The passcode may also be required depending on the machine configuration.
3.
Press the <Machine Status>
button on the control panel, and then select the [Tools] tab
on the screen.
4.
Select [System Settings] in the menu at the left side of the screen.
5.
Select [Connectivity & Network Setup]
in the [Group] menu.
6.
Select
[Protocol Settings]
in the [Features]
menu.
7.
Under [TCP/IP - IP Mode], select [IPv4 Mode], [IPv6 Mode], or [Dual Stack].
When IPv4 Mode or Dual Stack is selected in step 7.
a.
Select [IP Address Resolution], and then [Change Settings].
b.
Select [STATIC], and then select [Save].
c.
Select [IPv4 - IP Address], and then [Change Settings].
TCP/IP Address:
Gateway Address:
Subnet Mask (for IPv4) / Prefix (for IPv6):
DNS Server Address:
