e.
Select the
Technical Key Operator
icon. The Technical Key Operator feature displays.
f.
Select the bypass roll items that corresponds with the newly-replaced components.
g.
Select
Reset Current Value
. The system resets the High Frequency Service Item (HFSI) to 0.
h.
Exit the administrator mode by pressing the
Log In / Out
button on the control panel. When
prompted, select
Logout
.
Replacing the Tray 8 and 9 Feed Rolls
Use this procedure to replace the Tray 8 and 9 feed rolls.
To perform this procedure, the feed roll kit is required. The kit contains all the required items for
replacing the feed rolls.
Important:
If replacing the feed rolls for both trays, ensure to obtain two feed roll kits (one for
each tray).
Replace the Tray 8/9 feed rolls every 300,000 prints or when experiencing frequent multifeeds, single
feeds, or blank prints in the stack of the output prints.
The Tray 8/9 feed rolls which include the following components:
1. Nudger Roll
2. Feed Roll
3. Separator Roll (shown with the feed roll
removed)
276