Windows NT 4.x
Phaser® 8400 Color Printer
3-24
Verifying Settings
1.
Verify the settings in the “Configuration Page.”
■
IP Address Source
is set to:
DHCP
,
Front Panel
,
BOOTP
, or
Auto IP
(depending
on your network configuration).
■
Current IP Address
is set correctly. (Note this address if it is assigned by Auto IP,
DHCP, or BOOTP.)
■
Subnet Mask
is set correctly (if used).
■
Default Gateway
is set correctly (if used).
■
LPR
is enabled. Verify that the LPR and AppSocket settings are set as desired.
■
Interpreters
:
Auto
,
PCL,
or
PostScript
(depending on your driver).
2.
Verify that the client is logged into the network and printing to the correct print queue. The
user should also have access to the Phaser print queue.
Verifying Installation
1.
Right-click the
My Network Places
icon on the desktop and select
Properties
.
2.
Click the
Protocols
tab to verify that the TCP/IP protocol has been installed.
3.
Click
Add
to install any components not listed, then restart your computer.
4.
Click
Start
, click
Settings
, then click
Control Panel.
5.
Double-click
Services
.
6.
Locate
TCP/IP Print Server
, then verify these column entries:
■
Status
column:
Started
■
Startup
column:
Automatic
7.
Click
Start
, click
Settings
, then click
Printers
.
8.
Right-click the printer icon, then select
Properties
. Verify that you have installed the
correct driver for your printer.
9.
Select the
Ports
tab. Verify that the IP Address in the
Print to the Following Port
list is
identical to the one on the “Configuration Page.” You may need to click the
Configure
Port
button to view the IP address. If necessary, re-select the TCP/IP number used for
your printer.
Printing a Test Page
1.
Click the
General
tab.
2.
Click
Print Test Page
. If the printer still does not print, do one of the following:
■
Access
PhaserSMART
Technical Support on the
Troubleshooting
tab of your printer
driver.
■
Go to
www.xerox.com/office/support
.
