Xerox Phaser 3330, Руководство системного администратора

Страница: 20 / 92

Network Connectivity
20 Xerox
®
Phaser
®
3330 Printer
System Administrator Guide
TCP/IP
This section includes:
• Enabling TCP/IP at the Printer Control Panel ............................................................................................................ 20
• Configuring the Network Address Manually at the Control Panel ................................................................... 21
• Configuring IP Settings in Xerox ® CentreWare ® Internet Services.................................................................. 21
Computers and printers primarily use TCP/IP protocols to communicate over an Ethernet network.
Generally, Macintosh computers use either TCP/IP or the Bonjour protocol to communicate with a
network printer. For Macintosh OS X systems, TCP/IP is preferred. Unlike TCP/IP, however, Bonjour
does not require printers or computers to have IP addresses.
With TCP/IP protocols, each printer and computer must have a unique IP address. Many networks
and cable and DSL routers have a Dynamic Host Configuration Protocol (DHCP) server. A DHCP server
automatically assigns an IP address to every computer and printer on the network that is configured
to use DHCP.
If you use a Cable or DSL router, see the documentation for your router for information on IP addressing.
Enabling TCP/IP at the Printer Control Panel
Note: By default, TCP/IP is enabled. If you disable TCP/IP, enable it at the printer control panel
before you access Xerox ® CentreWare ® Internet Services.
1. At the printer control panel, press the Menu button.
2. Navigate to Tools , then press OK .
3. Navigate to Setup , then press OK .
4. Navigate to Network Settings , then press OK .
5. To enable TCP/IPv4, navigate to TCP/IPv4 , then press OK .
a. Navigate to IPv4 , then press OK .
b. Navigate to On , then press OK .
6. To enable TCP/IPv6, navigate to TCP/IPv6 , then press OK .
a. Navigate to IPv6 , then press OK .
b. Navigate to On , then press OK .