Xerox DP N24, Руководство системного администратора

Страница: 26 / 336

Installing the Printer
1-18
❖
DP N24, N32 and N40 System Administrator Guide
Installation Steps Follow these steps to set up your N40 printer. Remember to use
two people when lifting and carrying the printer.
You should have:
• Printer
• GFI (Ground Fault Interrupt)
(110 V or 220 V) +
Power Cord (220 V)
• Toner Cartridge (in a box)
• Face-up Bin Kit (in a box)
• Documentation Kit and CD-ROM
(Some parts may be inside a paper tray.)
1
Cut the shipping straps off the shipping
carton, lift the carton away from the printer
and unpack the printer.
Save the carton and packing materials for
later use in case you ever need to ship the
printer.
2
Remove the plastic bag and pieces of tape from
the printer.
3
Complete the registration card.
(See Step on page 1-19 for the location of the
serial number.)
4
If you are setting up the printer in its console
configuration, refer to Appendix C: Installing
and Removing Printer Options for instructions
on installing the 2,500 Sheet Feeder, then
return to this procedure.
5 With two people, lift up the printer as shown
on page 1-17 and place it on either the 2,500
Sheet Feeder (for console configuration) or on
a flat, sturdy surface that meets the space and
environment requirements discussed in the
sections “Space Requirements” (page 1-14) and
“Precautions” (page 1-15).
6
DP N40 options should be installed in the
following order: 2,500 Sheet Feeder, Printer,
Duplex Module, 10-bin Mailbox/Collator or
Finisher and 100 Envelope Feeder.