Xerox DocuPrint N3225, Руководство системного администратора

Страница: 79 / 325

Using the Menu System
Chapter 1: Configuring the Printer
❖
1-71
Port Timeout
Set the time for determining when to
end an incomplete print job and poll
the next port in the polling sequence.
The available values are:
5 - 300 seconds ( 30* )
This item also causes an implicit job
end such as Control D in PostScript or
<ESC> E in PCL, and invokes the
emulation functions associated with
this action (e.g., formfeed, reset, etc.).
The time changes incrementally by 1
second each time either
Value Up
or Value Down is pressed.
Holding down
Value Up
or
Value
Down causes continuous scrolling
through the values.
1. Press Menu Up or Menu
Down until you see:
Menus
Ethernet Menu
2. Press Item Up or Item
Down
until you see:
Ethernet Menu
Port Timeout
3. Press Value Up or Value
Down
until you see:
P o r t T i m e o u t =
New Value
4. Press Enter . You will see:
Ethernet Menu
Port Timeout
5. Press On Line . You will see:
Ready
Speed
Set the speed of the 10/100 Ethernet
interface. The available values are:
Auto*
10/Half
10/Full
100/Half
100/Full
This item does not appear when
the 10Base2 Ethernet Interface is
installed.
1. Press Menu Up or Menu
Down until you see:
Menus
Ethernet Menu
2. Press Item Up or Item
Down
until you see:
Ethernet Menu
Speed
3. Press Value Up or Value
Down
until you see:
S p e e d =
New Value
4. Press Enter . You will see:
Ethernet Menu
Speed
5. Press On Line . You will see:
Ready
Table 1.22 Ethernet Menu functions (continued)
Menu Item and Function Keystrokes Display
Table 1.22 Page 12 of 12