
OS/2 Warp Ser ver (LAN Server) Network
Quick Network Install Guide
❖
37
OS/2 Warp Server
(LAN Server) Network
Quick Install Steps
1
Print the Configuration Sheet. Details are in this
document in
Appendix A: Print The Configuration
Sheet
.
2
Check the Configuration Sheet and verify that both
TCP/IP protocol and proper connector are enabled on the
printer.
3
Create a new printer to load print drivers. Details for this
are found in the
Technical Information Guide
.
4
Create a network printer resource and its permissions.
5
Start LPRPORTD/LPRMON, ping printer, open EPM and
send a print job to the printer.
6
Check the print job for print quality. If print quality
problems exist, use the print quality section of your
printer
System Administrator Guide
to correct the
problem.
7
If your print job did not print, see the Troubleshooting
section for your operating system in the
Technical
Information Guide
to correct the problem.