Xerox DocuPrint N24, Руководство системного администратора

Страница: 34 / 398

Installing the Printer
1-24
❖
DocuPrint N24, N32, and N40 System Administrator Guide
Installation Steps
Follow these steps to set up your N40 printer. Remember
to use two people when lifting and carrying the printer
.
You should have:
• Printer
• GFI (Ground Fault Interrupt)
(110V or 220V) +
Power Cord (220V)
• Toner Cartridge (in a box)
• Face-up Bin Kit (in a box)
• Documentation Kit and CD-ROM
(Some parts may be inside a paper tray.)
1
Cut the shipping straps off the shipping
carton, lift the carton away from the
printer and unpack the printer.
Save the carton and packing
materials for later use in case you
ever need to ship the printer.
2
Remove the plastic bag and pieces of tape
from the printer.
3
Complete the registration card.
(See Step on page 1-25 for the location of
the serial number.)
4
If you are setting up the printer in its
console configuration, refer to
Appendix
C: Installing and Removing Printer
Options for instructions on installing the
2,500 Sheet Feeder, then return to this
procedure.
5
With two people, lift up the printer as
shown on page 1-23 and place it on either
the 2,500 Sheet Feeder (for console
configuration) or on a flat, sturdy surface
that meets the space and environment
requirements discussed in the sections
“Space Requirements” (page 1-19) and
“Precautions” (page 1-21).
6
DocuPrint N40 options should be
installed in the following order:
2,500 Sheet Feeder, Printer, Duplex
Module, 10-bin Mailbox/Collator or
Finisher and 100 Envelope Feeder.