Xerox DocuPrint N17, Руководство по обслуживанию

Страница: 490 / 558

6/98
Envelope Feeder Option 11-12 Xerox DocuPrint N17 Service Manual
11.3.5 One Way Clutch Assemblies A & B (26T)/Envelope Feeder
Solenoid(29T)/Transfer Clutch Assembly (25T)/Torque Clutch
Assembly
Removal
NOTE: Since the gears are greased, take care that the grease does not stick to your hands. If grease
sticks to your hands, wipe it off completely with a paper towel to prevent grease contamination of
other parts.
1. Remove the Bottom Cover ( REP 11.3.3 Bottom Cover/Tray Extension).
2. Remove the Side Cover ( REP 11.3.4 Side Cover).
3. Lift off the One Way Clutch Assembly A (26T) {Clutch and Gear} while holding the roll on the Feeder
Roll Assembly (See (1) in Figure 11.3.5.1).
4. Lift off the One Way Clutch Assembly B (26T) {Clutch and Gear} while holding the roll on the Feeder
Roll Assembly (See (2) in Figure 11.3.5.1).
5. Lift off the Transfer Clutch Assembly (25T) (See (3) in Figure 11.3.5.1).
6. Remove the Envelope Feeder Solenoid Bearing on the Envelope Feeder Solenoid (29T) (See (4) in
Figure 11.3.5.1).
NOTE: Be careful not to forget to reinstall the Envelope Feeder Solenoid Bearing when reinstalling the
Envelope Feeder Solenoid.
7. Disconnect J230 of the Envelope Harness Assembly from the Envelope Feeder Solenoid (29T) (See
(5) in Figure 11.3.5.1).
8. Lift off the Envelope Feeder Solenoid (29T) together with the Envelope Feeder Solenoid Shaft (See
(6) in Figure 11.3.5.1).
NOTE: The Feeder Bearing can sometimes come off along with the Envelope Feeder Solenoid Shaft.
Take care not to loose the Feeder Bearing (See (7) in Figure 11.3.5.1).
9. Separate the Torque Clutch Assembly Shaft (17T) from the Torque Clutch Assembly (See (6) in Fig-
ure 11.3.5.1).
10. Remove the KL Ring (See (8) in Figure 11.3.5.1).
11. Lift off the Retard Link (See (9) in Figure 11.3.5.1).
NOTE: Be careful when replacing the Retard Link, it must be installed with the top side up. Install the
Retard Link with the locating tab facing upward.
12. Lift off the Torque Clutch Assembly (See (10) in Figure 11.3.5.1).
13. Lift off the One Way Clutch Assembly (26T) (See (11) in Figure 11.3.5.1) while holding the Retard
Roll Assembly Shaft (See (12) in Figure 11.3.5.1)
NOTE: Be careful when reinstalling the One Way Clutch Assembly insure that the gear is oriented on the
bottom.
www.printcopy.info
www.printcopy.info