Page 4-18
Xerox WorkCentre 450c/450cp Service Manual
6.
Reinstall the bushings on the carriage
shaft.
7.
Attach the timing belt to the timing belt clip
as shown in Figure 4-20.
Figure 4-20 Attaching timing belt to
carrier
8.
Reattach the carrier and shaft assembly to the
printer.Position the bushings as shown in
Figure 4-21.
Figure 4-21 Bushing position
Timing belt
Timing belt clip
Index marks
Pointer
note
Ensure the ribbon cable is not twisted
after the carrier has been reinstalled in
it’s normal operating position.
9.
Wrap the timing belt around the encoder gear,
and then around the carriage motor gear.
10. When the timing belt is seated correctly, slide the carrier
back and forth along the shaft. It should move
freely with no binding.
www.printcopy.info
www.printcopy.info
