1
1-25
Setting up PostScript printing with Windows NT 4.0
Setting up SMB printing on Windows NT 4.0
SMB printing (also known as Windows printing) allows you to install the PostScript
printer driver and printer description files, and print from your computer to a
particular print connection (Hold, Print, or Direct) on the Fiery. These instructions
assume you have installed the TCP/IP protocol and Client for Microsoft Networks.
Each connection (Hold, Print, or Direct) requires a new printer driver and printer
description file. To set up printing to a second or third print connection, repeat the
procedure
“To set up SMB printing on Windows NT 4.0”
on page 1-26. If you install
more than one printer, give each a descriptive name during printer driver installation,
such as
Aero-Print
or
Aero-Hold
, so you can easily identify printers.
N
OTE
:
To change printer defaults and configure installable options from Windows
NT 4.0, you must log on as Administrator and use the password specified in Fiery
Setup. If you log on as a User, you can install the printer driver through Point and
Print, but you cannot modify printer defaults and configure installable options.
B
EFORE
YOU
BEGIN
•
Configure the Fiery for SMB printing from the Copier Control Panel in Run
Setup>Network Setup>Service Setup> Windows Setup.
•
Configure the Fiery for SMB printing from the WebSetup in WebSetup>Network
Setup>Service 2> Enable Windows Print Services.
SMB printing is referred to as Windows Printing in Setup on the Configuration page.
For more information, see the