Xerox DocuColor 2060, Руководство по планированию установки

Страница: 167 / 218

Defining the printer to the host: TCP/IP attachment
Installation Planning Guide F-5
Following is an example of the JES2 Initialization Dataset
required commands:
Configuring in
JES3
Follow these steps to configure the PSF printer in JES3:
1. Locate the JES3 initialization dataset (commonly known as
Initialization Deck) in the JES3 catalogued JCL Procedure.
(This is normally kept in SYS1.PROCLIB, although your
system may use a different library.)
The JES3 PROC has a JES3IN DD statement, which points
to the initialization dataset. The default initialization deck is in
SYS1.SAMPLIB (member JES3IN00); however, you should
verify your location by looking at the JES3 procedure.
2. Enter the following required commands in the JES3
initialization deck to define the PSF functional subsystem
(FSS):
• One FSSDEF statement for each PSF functional
subsystem
ROUTECDE None Installation
printer name
standards 1 to 4
destination
names If WS if F, only output
with these destinations
is selected for this
printer.
START YES Should be NO
for TCP/IP
printers. YES or NO START=NO should be
specified so TCP/IP
can be started before
the FSS.
TRKCELL no See JES2
SPOOLDEF
statement YES or NO IBM recommends
YES.
WS None Installation
preferences See JES2
Initialization
and Tuning
Manual. Consider CL, R, and F.
See JES2 Initialization
and Tuning Manual for
more information.
Table F-1. JES2 FSS statement parameters (Continued)
Item
description
Default
Source of
value
Range of
acceptable
values
Comments
Your
value
Table F-2. JES2 Initialization Dataset commands example
FSS (FSS1) PROC=FSSPROC1,HASPFSSM=HASPFSSM,AUTOSTOP=YES
PRT0001 CLASS=E,FSS=FSS1,MODE=FSS,PRESELCT=YES,
START=NO,TRKCELL=YES,WS=(Q)