NOTE:
When the battery is low the device will enter a protective state in where the camera cannot be
turned on.
Pressing the power button slightly a yellow light will start to blink, indicating that the device is
ready to be used. Then pressing the Record / Stop button slightly, another yellow light will begin
to blink followed by a slow flashing red light. At this time the device will start to record. To stop
the recording just simply press the Record / Stop button again and the video will stop and save
automatically. The red light will remain after the video has saved if you wish to continue
recording.
NOTE:
a.
Make sure the Micro SD card has been inserted before use. If not, the device will power
off automatically after 30 seconds.
b.
To avoid saving incomplete files, do not press any of the buttons during the saving
process.
c.
For the best results when making a video, focus on the object and keep 50cm under
sufficient illumination, the video will then remain natural and clear looking.
Pressing the power button slightly, a yellow light will start to blink indicating that the device is
ready to be used. Then press the Mode button to switch in to sound control, a red light will start
to flash to signify this. When the decibel reaches 60, the device will start to record automatically
for 2 minutes. If after 2 minutes there is no sound, the device will save automatically and switch
to standby mode. If there is still sound after 2 minutes then the device will carry on filming.
On the CD provided with the product there will be a file named time synchronization. When the
device is connected to the computer the time will synchronize with the time displayed on the
computer.
POWER ON TO VIDEO
VIDEO SOUND CONTROL (OPTIONAL)
SETTING THE TIME