Portable LED HeadLight System (XD Light) www.xenosys.co.kr
13
1.
Assemble the control unit & battery pack, then press power ON/OFF button to start.
①
Check the light comes out from LED lens module.
②
Check the battery remaining signal of control unit. ( Battery remaining signal
will be shown green, orange, blinking orange in turn.)
③
If fully-charged battery installed, it will show “Green”. As battery will be exhausted,
the remaining value will show “Orange”. At 30% left battery, it will start to blink
orange color. “Beep” alarm sound will come on less than 10%, and we recommend
recharging the battery. After “Beep” sound, the power will shut down after 10
minutes.
Caution – Please recharge when hearing “beep” sound and only a few moments light
come which means the battery is not charged.
2.
Press the intensity change button to adjust desired brightness. ( )
One press will apply to change one step each (STEP 1
st
, 2
nd
, 3
rd
, 4
th
).
Below table will indicate LED lens module brightness (lx@WD400mm) & operating time.
LED Lens Module
Step
Brightness(lx) @WD400mm
Operating
Time(hr)
DLM82
DLM150
1
st
9,000
3,000
22
2
nd
16,000
6,000
11
3
rd
23,000
9,000
7.5
4
th
29,000
11,400
5.5
3.
Adjust LED lens module up-down or left-right to locate the desired position.
Caution – External LED lens module’s temperature will go up to max. 46℃ during
usage, so be careful.
4.
After finishing the usage, press the power ON/OFF button to turn off.
