Setup
1.
Depress the lock pin on the left side of the deck (see the
drawing below). Pivot the upright up until it locks into a
nearly vertical position. Turn the release knob clockwise
until it is tight.
2.
Insert the handles into the stem until the lock pins are visi-
ble in the holes in the stem.
3.
Open the quick-release lever. Depress the lock pin on the
stem, and slide the stem up until the lock pin is visible in
the top hole. Close the quick-release lever so that it is snug
against the upright. If the quick release is not snug, see
ADJUSTING THE QUICK RELEASE on the back of this
user’s manual.
Before using the scooter, make sure that the scooter is set up
as described and that all parts are securely tightened.
The decals shown at the right have been placed on the
scooter. If a decal is missing, or if a decal is not legible,
please call our Customer Service Department toll-free at
1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m.
Mountain Time, to order a free replacement decal. Apply
the replacement decal in the location shown.
Storage
1.
Open the quick-release lever. Depress the lock pin on the
stem and slide the stem into the upright. Close the quick-
release lever.
2.
Depress the lock pins and remove the handles from the
stem. Press the handles into the storage clip on the upright.
3.
Turn the release knob counterclockwise until you can pull it
out, and pivot the upright down past the lock pin into the
horizontal position.
Release Knob
Release Knob
Storage Clip
Rear Brake
Stem
Groove
Front
Left Side
Right Side
Quick Release
Handle
Handles
Upright
Lock Pin
Lock Pins
Lock Pin
Upright
