data will be copied from the master chip to the buffer memory.
o
To make sure the loaded data is correct one can review the
information in the
Buffer
window.
o
If desired, you can save the data to a disk for later use.
NOTE
: The read function is not available for some devices, including those
have been encrypted.
3.2.3
Set options
Click
Operation Option
from the Option menu to open the Operation Option
screen. Set each of the following options:
o
Insertion Test
indicates whether to check the pin contact.
o
Device ID Check
indicates whether to check the ID of the device.
o
Beeper
indicates whether the beeper alarms a sound when the
operation succeeds/fails.
o
Auto Increment Function
indicates an automatic increase in the label
number written to each chip.
o
Address Change
indicates whether a different start and end address
shall be applied for the programming zone of the device.
To set the order of the batch processing functions, select
Edit Auto
from the
Options menu. The system displays the Edit Auto screen.
For devices that include the configuration word, you must set the
configuration word before programming to ensure that the chip can be used
on the target system. The configuration words for some devices are contained
in the data file. Therefore, the system automatically loads the configuration
word into the configuration word buffer when loading the data file. For some
devices, you must manually make the selection. Select
Device Configuration
Word
from the Device menu to open the ConfigWord screen.
Many devices must meet some special requirements for the programming of
a chip, including special algorithms conventions. Read the device manual or
instructions carefully and adjust the operation steps or buffer data as needed.
