MM-202BX
Installation Manual
This document is subject to change without prior notice.
10
4. Installing the MM-202BX
4.1 Connecting the Power
Plug the power cable of the MM-202BX into an available power outlet in the distribution
station or panel
1
.
4.2 Configuring the MM-202BX
The MM-202BX is remotely configured by the EU-200BX through automatic process. Therefore
there is no need to manually configure the MM-202BX
2
.
4.3 Connecting the CU-100A to the MM-202BX
The CU-200A is usually installed near the circuit breaker of each subscriber’s house. Use a
straight RJ-11 cable to connect the MM-202BX and CU-100A. The RJ-11 cable is not included
with the MM-202BX
3
.
①
Insert one end of the RJ-11 cable in the
SIG1 or SIG2
port of the MM-202BX.
②
Insert the other end of the cable in the
INPUT
port of the CU-100A.
Figure 5 Connecting the MM-202BX to the CU-100A
1
If there is no available power outlet, connect the Hot line and Neutral line from the public
power supply in order to provide power to the MM-202BX. Be careful not to use private
powerlines.
2
Please refer to the EU-200BX Installation Guide for more details.
3
The RJ-11 cable is not included with the product because the distance to each subscriber’s
house varies widely according to the site configuration. The RJ-11 cable should be a straight
cable with wires in the same sequence on both ends.
