XCLEAR BEADFILTER 400, Руководство пользователя

Страница: 9 / 32

9
WINTERIZING YOUR FILTER
It is best for all biological filters to operate 24/7.
Sludgedrain
If you live in an area where you experience hard freezing, you may decide to shut your filter down for the winter. Do the
following:
1. Do a good backwash of the filter. Move the multiport valve to the “winter” position ( between CLOSED and WASTE) .
2. Turn off your pump and open the drain plugs on the pump strainer basket.
3. Open the drain plug at the base of the main filter and then the air release valve at the top of the filter. Water will drain out of the filter, but
no beads will be lost (Xclear Beadfilter 400/500/600). CAUTION! The Xclear Beadfilter 750/900 do not have a valve outlet with strainer
which causes the beads to come out of the filter. Keep close attention when the beads start coming out of the filter and close it. Then open
the valve a little bit so only water can come out and no beads.
4. Loosen all connections and drain exposed pipes, so that no water will be trapped. This is especially important for your UV lights!
In the spring:
1. Tighten all the connections that you loosened in the fall.
2. Move the multiport valve to the filter position and open the air release valve at the top of the filter and close the drain plug. Turn on the
pump. When water comes out of the air release valve at the top of the filter, shut it and turn off the pump. Now do a good backwash and
rinse before going to the filter mode. Back up to full capacity. During the first few weeks of operation in the spring, it is a good idea for the
pond owner to do frequent checks of the ammonia and nitrite levels.