XciteRC 56 XS ROCKET 3D, Руководство пользователя, Страница: 22 / 40

22 XciteRC Rocket 65XS
EN
Landing
·
Model calibration
·
Maintenance
Landing:
• Carefully push the left throttle lever rearward. Try to land „smooth“ without damaging the Quadrocopter.
• NOTE: if the flight battery runs empty, the Quadrocopter does not respond accurately to your com-
mands, the flight is unstable. In this case land immediately.
• Switch of the Quadrocopter and then the transmitter.
WARNING: the motor of the XciteRC Rocket 65XS may get very hot during operation. Allow to cool
down minimum 20 minutes before the next start to avoid damage. Fire hazard!
Model calibration
If the quadcopter flies no longer stable, e.g. after a serious crash, it may
be necessary to calibrate it again. Proceed as follows:
• Turn the model on as usual, then move throttle lever once all the way
up and down to bind the model.
• Move and hold both control levers in the lower right corner. After a
few seconds the models LED‘s will start flashing to indicate that the
calibration has been successfully completed.
Maintenance
To have fun with your model over a long period, occasional service work is required to get your model in good
condition and to minimize wear.
• Remove dirt or dust depending with compressed air or a soft brush after each use. For stubborn dirt, a
harder brush or a toothbrush can be used.
• To clean the body/fuselage no chemical cleaners such as thinners may used, as this damage the plastic
of the body/fuselage. Normally a piece of soft cloth is ok, stubborn dirt can be removed with washing-up
liquid.
• Check the tightness of all screws and tighten if necessary.
• Also check all connections, cables and power battery / rechargeable battery for damage.
• WARNING: Damaged batteries or rechargeable batteries must not be used again and must be
disposed of immediately – fire hazard! Please note the disposal notes at the end of this manual.
• Check the model for worn, broken or jammed parts and gears and repair if necessary.
• WARNING: remove the batteries / rechargeable batteries of the transmitter and model when not in
use – fire hazard!