04
©
2015 Hubsan
哈博森科技 版权所有
3. QUAD COPTER BATTERY
3.1 INTRODUCTION
The quad copter battery is rechargeable with 2700mAh capacity and 7.4V voltage.
The battery should ONLY be charged with the HUBSAN charger to avoid overcharge.
3.3 CHARGING
Connect the battery to the balance charger and wall charger. The balance charger
indicator is solid red when charging and turns to solid green when the battery is fully charged.
It takes around 210 minutes to get the battery fully charged.
3.2 INSTALL THE BATTERY
Push the battery into the battery compartment
correctly and connect the battery plugs with the
correct polarity.
Close the battery compartment cover.
7.4V 2700mAh 10C
2. QUAD COPTER MOTOR LED INDICATOR
Please fully charge the batteries to avoid loss of control due to low voltage.
Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the local regulations.
Indicator Status:
1. Power on: 4 white LED indicators blink simultaneously every 1.5 seconds.
2. Compass Calibration:
1). Horizontal calibration: 4 red LED indicators blink circularly.
2). Vertical calibration: 4 green LED indicators blink circularly.
3. GPS Flight: 4 LED indicators remain blink. .
4. GPS Return : 2 front LED blink in white, 2 back LED blink in blue.
5. Altitude Hold: 2 front LED blink in white, 2 back LED blink in yellow.
6. Position Hold: 2 front LED blink in white, 2 back LED blink in green.
7. Low Voltage: 2 front LED blink in white, 2 back LED blink in red.
8. LED indocators can be turned off by long pressing the LED indicator SW on transmitter.
Содержание 15030000
Страница 19: ...19 X4 FPV Brushless DE ...
Страница 42: ...22 2015 Hubsan 哈博森科技 版权所有 ...