Xcel-Arc VIPER TIG 200P, Руководство по эксплуатации

Страница: 19 / 36

VIPER 200P TIG Welder Manual | 19
TIG WELDING GUIDE
100A
40A
Peak
Amp
Base
Amp
100A
Peak
Amp
Base
Amp
100A
60%
40A
40%
Peak Amp
On Time
Pulse Width
Peak
Amp
Base
Amp
100A
60%
40A
40%
100A
60%
40A
40%
The VIPERTIG 200P machine has digital pulse frequency control. The Peak Amp and Pulse Frequency
time are adjustable, where as the Base Amp and Pulse Width are preset for ease of use.
EXAMPLE OF PULSE DC TIG WELDING - SETUP PARAMETERS:
Material = Stainless Steel x 2.0mm / Tungsten Electrode = 1.6mm E3 Tungsten / Gas = Argon
The following steps are a guide as a starting point for you to set the machine up in Pulse mode to give an
example of welding in Pulse mode function. You can experiment by changing any of the variables to see
what effect it has over the welding and what the end result can be, but it is suggested to change only one
variable at a time and then check the welding to see what the result is, in this way you acquire a better un
-
derstanding of how each variable affects the welding current.
Time = 1 Second (Hz)
1.
Select DC Pulse by pushing
selector button to cycle through to
illuminate DC Pulse icon.
2.
Select the Peak Amps using the Amps
control knob.
3.
Rotate the Adjustment Knob to set the Peak
Amps at 100A
(Range is 10-200 Amps)
4.
The Peak Amps are now set at 100. Because the Base
Amp is preset in the machine at 40% it means that the Base
Amps will be 40Amps. So the machine now will deliver a
cycle of 100Amps - 40 Amps
5.
The Pulse width is also preset inside the machine for
ease of use. Pulse width is the amount of time the peak amp
is on during the pulse cycle. The machine is preset at 60%
pulse width time. In this case it means the machine will
deliver 100amps for 60% of the time and 40amps for 40%
of the time during each pulse cycle.
40A
2.
Select the Pulse Frequency using the
Pulse Hz Knob.
3.
Rotate the Adjustment Knob to set the Pulse
Frequency 2 Hz. This means the amperage will
cycle from 100 amps to 40amps 2 twice per
second.
(Range is 0.2 - 200Hz)
Setting the Pulse Amps
Setting the Pulse Width
Setting the Pulse Frequency
Set up and operation for DC PULSE TIG Welding