Connecting to Wi-Fi
The router card is preconfigured to connect to a Wi-Fi network
with the following credentials.
SSID
WPA2-PSK
xaprc_default
password123!
Once connected, you can change the configuration remotely
using the
enfcli
.
1. Configure a Wi-Fi access point
2
with the SSID and passphrase
listed in the preceding table.
IMPORTANT:
The Wi-Fi access point must be connected to
the Internet.
2. Power on the host device and wait 30 seconds for the router
card to connect. Check the connection status using the
captive get-device-status
command. Use the serial num-
ber printed on the router card as the device id.
enfcli-user@demo> captive get-device-status
--device-id=XRW04419003028
Serial Number : XRW04419003028
WIFI
:
connected
: true
SSID
: xaprc_default
IPv4 addresses : [ 192.168.1.56 ]
The following steps create a new profile and Wi-Fi configuration
for this device. To use an existing profile, skip to step 5.
2
If you don’t have an access point, configure a smartphone
hotspot
instead.
8
