Xantrex XW4024-120, Руководство по эксплуатации

Страница: 63 / 112

Multi-Unit Config Menu
975-0240-01-01 3–25
Setting the Device Number
Setting the device number gives a Xanbus-enabled device a unique identity when
several devices of the same type are installed in the networked power system.
When each identical device has a unique number, the System Control Panel can
correctly identify and display status information for each device.
A device number consists of two digits ranging from 00 (default) to 31.
If only one of each device is installed in the networked power system, you do not
need to set the device number. However, it is encouraged to set the device number
to a value other than 00. 00 is a factory default value and can be used to indicate a
“Restore Defaults” command was successfully performed if the value was
previously different.
To set the XW Inverter/Charger device number:
1. On the XW Inverter/Charger Setup menu, select Advanced Settings.
If “Basic Settings” appears instead of “Advanced Settings” on the Setup
menu, display “Advanced Settings” by pressing Enter + Up arrow + Down
arrow simultaneously.
On the Advanced Settings menu, select Multi-Unit Config and press Enter.
2. On the Multi-Unit Config menu, select Dev Number. See Figure 3-6.
3. Press Enter to highlight the instance number.
4. Use the up and down arrow buttons to adjust the two-digit identifier number.
5. Press Enter.
Figure 3-6 Setting a Device Number
XW6048 01:Multi
Dev Number
[XW1]
[01]
[SplitPhSlave]