Xantrex XW4024-120, Руководство по эксплуатации

Страница: 26 / 112

Monitoring Operation
2–4 975-0240-01-01
Equalizing Batteries
Button Pressing the Equalize button (indicated by the symbol) for five seconds turns
battery equalization on and off. After this button is pressed, the XW Inverter/
Charger begins the equalization charge after the next charge cycle is complete.
Equalization functions only if AC is present and qualified and the charger is
enabled. Otherwise the inverter/charger generates a “cannot equalize” fault
(W96).
For more information, see “Equalize Charging the Batteries” on page 3–13
LED The yellow Equalize LED indicates that the XW Inverter/Charger is equalizing
batteries.
Symbol LED On LED Flashing

The XW Inverter/Charger has a fault
and has stopped charging or inverting.
The LED also turns on steadily if the
unit has both a fault and a warning. The XW Inverter/Charger has a
warning. Warnings may escalate to
a fault if the warning condition
does not go away.
CAUTION: Battery damage
Equalization may damage your battery. Consult your battery supplier for details on
equalize charging for the battery type in your system.
Important:
In a system where more than one device is capable of equalizing batteries
(such as a system including multiple XW Inverter/Chargers and Solar Charge Controllers),
there is no system-wide equalization command for all devices. To equalize with multiple
devices, each would have to be enabled individually. Alternatively, equalization can be
performed using only one device. During the equalization process, one device applies the
equalization charge while the other devices continue to operate in synchronized charge
mode, typically in float (three-stage charging) or no-float (two-stage charging).
Symbol LED On LED Flashing
The XW Inverter/Charger has
begun equalizing the batteries. Equalization has been enabled but has
not begun. The XW Inverter/Charger
must complete a charge cycle before
applying the equalization charge.