![background image](http://html1.mh-extra.com/html/xantrex/trace-1012-ur-ups/trace-1012-ur-ups_owners-manual_881578030.webp)
22
2.0 Installation
©2002 Xantrex Technology Inc. All Rights Reserved.
P/N 975-0049-01-01 Rev A 10/2002
AC Wiring (continued)
Hardwiring the AC Input and Output (if required)
Output Wiring
1.
Install a conduit or strain relief in the rear panel AC
OUT knockout hole.
2.
Feed the AC output cord through the strain relief to the
subpanel designated for the desired loads for the Trace
UR-UPS (not the main electrical utility box).
3.
Strip all wires back approximately 3/8 inch (10 mm).
4.
Connect the green/yellow (ground) wire to the lower
terminal on the main PC board.
5.
Connect the blue or white (neutral) wire to the center
terminal on the main PC board.
6.
Connect the brown or black (hot) wire to the upper
terminal on the main PC board.
7.
Torque all screws to 16 inch-lb (1.8 Nm).
8.
Tighten the screws on the strain relief (leave some slack
in the wire before tightening).
9.
Reinstall the cover following the instructions on
page 8.
HOT
NEUTRAL
GROUND
Figure 2-16
Wiring AC Output to Terminal Block
Содержание Trace 1012 UR-UPS
