Xantrex GRIB and Ethernet interface, Руководство по эксплуатации

Страница: 29 / 70

Basic Section
M370078-06 2-5
Network Topology and Connection
The following section describes the network topology for the single
computer and single XG power supply unit. The other possible network
topologies will be discussed later in the “Advanced Section” on page 2–
26. The additional topologies build on the configuration ideas present in
this section by referencing the various setup instructions.
Single Computer and Single Power Supply Unit
Figure 2-6 shows the connection between the ENET unit and Local
Computer through a crossover cable; however, a HUB could also be used
with straight through Ethernet cables as well. Connect your computer to
the ENET as shown in Figure 2-6, or if this topology does not match your
configuration, refer to the “Advanced Section” on page 2–26 to identify
the topology you wish to implement and follow the instructions described
in that section.
Figure 2-6 Single Computer, Single Power Supply
ENET
Local Computer
Power Supply