Installing the Remote Panel Unit on the Wall
http://www.xantrex.com
PN: 808-0817 / 808-0817-02
Freedom X Remote Panel User Guide
7
A
976-0367-01-01 Rev D
09-2019
Copyright © 2018 Xantrex LLC. All Rights Reserved.
All trademarks are owned by Xantrex LLC or its affiliated companies. Other trademarks are
owned by their respective companies.
page 3
Creating a Bluetooth Link with the Freedom X Remote Panel App
1. Download and install the FXC Control app into a
compatible Android or iOS smart device.
The Freedom X Remote Panel app (
FXC Control
)
allows you to conveniently monitor and configure a
Freedom X inverter (or a Freedom XC inverter/charger)
a
with a compatible smart device
b
using a Bluetooth
connection.
2. Turn on the Bluetooth enabled Freedom X Remote
Panel by using the ON/OFF button on either its own
front panel or the connected inverter’s front panel.
3. Launch the FXC Control app on your smart device.
4. Turn on the smart device’s Bluetooth through the
Bluetooth toggle on the app. The app should now
indicate that it is searching for devices.
5. On the Freedom X Remote Panel, press and hold the
ESC button to enable Bluetooth pairing on the remote.
Remote pairing can be observed by the two flashing
horizontal lines underneath the left and right numbers.
6. When the app has detected the Bluetooth signal, it will
display the connected inverter’s serial number in the
app. Click on the serial number to complete the pairing
process.
7. To stop the Bluetooth connection, disable the smart
device’s Bluetooth connectivity.
_____________________________________
a
List of compatible Freedom X/XC units:
817-1000, 817-2000, 817-2000-21, 817-3000,
817-1050, 817-2080, 818-2010, 818-3010, 806-1212
b
Compatible smart devices:
iPhone oriPad running iOS 8 or higher
Android phone or tablet running v8 or higher with Bluetooth
Low Energy compatibility
FXC Control
FXC Control
1. Place the template on the wall.
2. Mark the corners (or trace the dotted lines) of the
recess outline on the wall.
3. Mark the two mounting holes for the two screws
on the wall.
4. Remove the template from the wall.
5. Cut along the recess outline on the wall to make
a hole for the remote panel’s body.
6. Pre-drill the mounting holes appropriate to the
mounting screws (not provided) that will be used.
7. Connect the 6-conductor com cable to the RJ12
ports on the inverter and remote panel.
8. Mount the remote panel unit on the wall.
recess outline
mounting
hole
mounting
hole
Mounting Template
126.0 mm
107.0 mm
51.0 mm
NOTE
: Ensure the inside wall is free of obstructions,
such as pipes, insulation, and electrical wiring.
Ensure the recess depth is more than 50 mm.
allow enough
space for
connecting the
com cable plug
38.0 mm
C
M
Y
CM
MY
CY
CMY
K
976-0367-01-01_Rev-D(artwork).pdf 3 9/25/2019 4:40:57 PM
