Xantrex Freedom X 1200, Руководство пользователя

Страница: 59 / 100

Basic Installation Procedures
975-0767-01-01 57
Step 7: Connecting to Port(s) on the
Freedom X 1200
Connecting to ACC Signal
The Freedom X 1200 can be wired to inhibit inverter operation in
the absence of a vehicle’s (or vessel's) ignition control signal. This
feature can avoid unnecessary battery drain that would otherwise
occur if the inverter was operated without a charging source such
as the vehicle alternator.
To enable ignition control:
1. Ensure that AC and DC power are both OFF.
2. Ensure the vehicle’s ignition is turned to OFF position. It is
highly recommended to remove battery power by
disconnecting the vehicle's battery cables. Refer to the
vehicle’s user manual for proper instructions on how to
disconnect the battery cables.
3. Locate the vehicle's ignition control wire from the vehicle’s
ignition circuit. This wire must be fused appropriately at no
more than 5 A. Refer to the vehicle’s user manual for
guidance.
4. Locate the ACC input (ignition signal input) terminal on the
left side of the connector. The rectangular slot on the right is
used to release the spring clamp. See
Figure 17
Figure 17 Ignition signal (ACC) input terminal
5. Using a 3mm slot long neck screwdriver, push into the
rectangular slot to release the spring clamp.
6. Insert the ignition control wire into the round ACC input
terminal slot.
7. Pull the screwdriver out to engage the spring clamp and
secure the wire to the terminal.
NOTE : The mechanical elements of the ACC input terminal works
in conjunction with the Ignition Control features set separately
from the display panel.