Xantech ELAN Xtranet XLIP200, Инструкция по интеграции

Страница: 10 / 11

10 of 11
G
! C
ONFIGURATION
D
ETAILS
In the tables, the following items appear:
o
“<Select>” Select the desired item from the list (or drop-down) in Configurator.
o
“<User Defined>”, etc. Type in the desired name for the item.
C
ONFIGURING
IR O
UTPUTS
This table provides settings used in the Configurator to setup the IR outputs on the XANTECH XLIP.
Configure the IR outputs on the Input/Output tab in Configurator.
Devices Variable Name Setting Comments
Communication Devices Device Name <User Defined> (Default: Xantech XLIP)
Communication Type Standard Connecton
Hardware Type (IP to Serial) Xantech XLIP232
Device <Discovered>
IP Address <User Defined> (Default: 192.168.1.33 ) (See Note 1)
Port 65432
IR Senders Name
<User Defined> For eg:
Comcast (IR2)
Device Type Xantech XLIP
COM Device <Select> (Default: Xantech XLIP )
Output Number <Select> 1 or 2 for IR output #1 or #2
IR Receiver Name
<User Defined> For eg:
Comcast (IR2)
Device Type Xantech XLIP
COM Device <Select> (Default: Xantech XLIP )
RS-232 (XLIP232 Only) Name <User Defined>
Communication Type Standard Connection
Hardware Type (IP to Serial) Xantech XLIP232
XLIP Device <discovered>
Ip Address <user defined>
Port <User Defined>
Notes:
1. By default, set the Xantech XLIP to 192.168.1.33. If you have more than one Xantech XLIP, set the second to 192.168.1.34 and so on.
C
ONFIGURING
RS-232 P
ORTS
This table provides settings used in Configurator to setup the serial port(s) on the XANTECH XLIP.
Configure the serial ports on the tab of the system that the serial port will connect to.
Important: Configure the XLIP IR outputs as shown above before configuring any XLIP Serial ports.
Devices Variable Name Setting Comments
Communication Devices Name <User Defined>
Communication Type Standard Connection
Hardware Type
(IP to Serial) Xantech XLIP232
XLIP Device
<discovered>
Ip Address
<user defined>
Port <User Defined>
Note: By default, set the XLIP to 192.168.0.41. If you have more than one XLIP, set the second to 192.168.0.42 and so on.
IMPORTANT: The XLIP232 serial port’s baud rate must be configured on the XLIP device and not in
the g! configuration software..