F
EDERAL
C
OMMUNICATION
C
OMMISSION
I
NTERFERENCE
S
TATEMENT (Only for xCL_AT-100-R6-18U)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
Radiation Exposure Statement:
The product comply with the FCC portable RF exposure limit set forth for an uncontrolled
environment and are safe for intended operation as described in this manual. The further RF
exposure reduction can be achieved if the product can be kept as far as possible from the user limb
or set the device to lower output power if such function is available.
Specific Absorption Rate (SAR) Testing Your device has been designed to comply with applicable
limits for RF exposure. These limits use a unit of measurement called Specific Absorption Rate, or SAR,
which refers to the rate at which the limb absorbs RF energy. The Federal Communications
Commission (FCC) has established a SAR limit for mobile phones of 1.6 W/kg, which applies in the
United States and other countries that follow the FCC’s SAR limit.
SAR testing is conducted with the device placed in common operating positions (e.g., held against
the head, worn on the limb) and transmitting at its highest certified power level in each frequency
band of operation. Because the device is transmitting at its highest certified power level, SAR tests
capture a worst-case operating scenario and therefore often do not reflect the amount of RF
exposure during normal, everyday use.
More information on SAR testing is available on the FCC’s website at
http://www.fcc.gov/guides/
wireless-devices-and-health-concerns.
XAC Automation Corporation submitted SAR test results demonstrating compliance with the FCC’s
SAR limit for wireless devices as part of the FCC’s equipment certification process for this device.
These results can be accessed via the FCC’s equipment authorization database (found
at
http://transition.fcc.gov/oet/ea/fccid/
) by searching for the device’s FCC ID: MQT-AT100R6.
