Operating Temperature: 0
C to 40
C.
RTC battery spec. : 5V, CR2032.
Power Adapter: Input rating: DC 24V, 4.17A
(Use only the XAC Automation Corporation provided AC adapter approved for use with this
device. Use of another AC adapter may cause a fire or explosion)
4.
L
OADING THE
P
APER
Gently press the “Open” button on the cover’s left side (Figure 10). Load a roll of thermal paper
(Appleton 1012 recommended) into the TP72-HUB2. (Figure 11) Load it so that the print-side of
the paper will feed out facing the operator. Close the cover by pressing down. TP72-HUB2
integrated 3” Thermal printer with auto-cutter. Press the “Feed” button to adjust the paper
position and cut paper. (Figure 12)
Figure 10 Figure 11
Figure 12
If run out of paper, the “Paper Out” LED will light in orange. While an error occur, the “Error”
LED will light in red. (Figure 13)
Figure 13
5.
W
IRELESS
C
OMMUNICATION
O
PTIONS
There are two wireless communication options used in TP72-HUB2. (Figure 14)
-
Support Bluetooth (MFI) communication as a device.
-
Support Wi-Fi communication as a device.
Figure 14
6.
P
OWER
O
FF
Press and hold the power button (3 seconds) at the left side of device until the “Power” LED is
turn off to complete power off TP72-HUB2.
