13
operating manual.
» Never immerse the product into water or other fluids and do not attach the
LED-band onto wet or electricity conducting underground.
» Do not connect the LED-strip with different or additional lighting systems of
the same type.
» The maximum power must not be exceeded, this could destroy the product.
» Do not operate the product if it is covered.
Installation and Application
»
Remove the product from the packaging. The product may only be used
outside of the package and unfurled.
»
Clean the area to which the product is to be attached. These areas must be
sufficiently even, clean and free from grease to ensure optimum adhesion of
the LED-strip.
NOTICE:
Follow the safety instructions found in chapter “Cleaning”.
»
When choosing the mounting place, take care the LED strip with attached
USB cable can reach an appropriate USB socket and the IR receiver cable can
recognize signals transmitted by the remote control.
»
Remove the protection foil from the adhesive tape on the backside of the LED
strips and push the strips tightly onto the desired place for a few seconds.
»
The last LED strip that is only connected to the other LED strips on one side
can be shortened approx. every 4 cm, but can not be extended. Never shorten
the LED strip while it‘s connected to electricity.
»
To shorten the LED strip cut the strip with scissors at the whited dotted lines
as seen on page 24, fig.
Already processed or cut strips are excluded from reclamation, conversion
D
EU
TS
C
H
ENG
LI
SCH
FR
A
NZÖ
SI
SC
H
