26
how to insert the batteries into the magnet sensor
The transmitter of the magnet sensor requires an AA battery. Replace the
batteries as follows:
» Open the case by inserting a broad slot screwdriver into the aperture at the
lower edge, then turn carefully.
» Insert the battery and mind the correct polarity. The negative pole must point
towards the spring.
» Shut the case by pressing both halves firmly against each other.
Installation of your Security DIY alarm
Before you start, insert all batteries into the respective transmitters and plug
the hub into an electrical outlet within the range of your wireless network. Then
follow these steps one by one:
1. Download the app
Scan the appropriate QR code for your operating system in this manual or find
the app “An-Home” in the Apple or Google store.
Proceed with the installation of the app.
2. Connect your smartphone with the alarm system
» Press the On/Off-switch on the hub three times. After each pressing, a beep
must be heard. Then a repeating beep will start. This is the pairing mode.
701552_Security-DIY_12x15-MAN.indd 26
10.01.2017 10:37:51