X-Tronic 4040-XTS, Инструкция по эксплуатации

Страница: 13 / 16

- 11 -
11. Replace the heating element.
12. Solder the new element leads in the correct location.
13. Pull the cord out of the bottom of the soldering iron while pushing
the new element into the top, aligned with the notches.
14. Replace the plastic nut on the top of the iron and tighten.
15. Replace the small inner metallic shaft.
16. Replace the tip over the heating element.
17. Replace the outer metallic shaft of the soldering iron.
18. Replace the metallic nut and tighten.
Hot Air Gun
1. Turn off the unit and unplug from the power source.
2. Allow the unit to reach room temperature before proceeding.
3. Remove any attachments that are on the hot air gun.
4. Remove the 3 screws on the hot air gun.
5. Slide the silicone tubing off of the hot air gun.
6. Pull the two halves of the hot air gun apart (they are glued
together).
7. Slide the metallic shaft off of the heating element.
8. Remove the fiberglass paper from the heating element.
9. De-solder the broken heating element paying special attention to
the wire color and placement.
10. Solder the new heating element leads in their correct places.
11. Wrap the heating element in the fiberglass paper.
12. Slide the metallic shaft over the heating element and place it
back into the hot air gun, lining up the holes with the standoff
present in the gun.
13. Put the two sides of the hot air gun back together, lined up with
the holes on the metallic shaft.
14. Reinsert the 3 screws and tighten them.
15. Reattach the silicone hose.