X-TREME XB-610, Руководство пользователя

Страница: 17 / 31

17
How To Fix Wobbly Handle Bars
1. Remove the instrument panel by taking out the six (6) screws from the bottom and
disconnecting the wire connectors
2. Look at the bolt that clamps the handle bars to the steering stem: is the gold spacer seated
correctly?
3. Tighten the bolt by using two 14mm wrenches – one from above on the front of the bolt and
the other by reaching up under the wheel well to hold the nut in place while the front one
tightens the bold snuggly.
4. Check handle bars for secure fit. If still wobbly remove bolt, reset handle bars and tighten.
Having the bolt securely tight will eliminate the handle bars from wobbling.
How To Center Handle Bars
1. First remove the dash. You should not have to remove it completely, but at least split it so you
may access the space in the center of the handle bar.
2. In the center of the handle bar you will see the head of a small bolt.
3. Loosen this bolt up slightly until the handle bars can move to the correct position.
4. When the bars are aligned properly tighten the bolt.
5. Reassemble the dash pieces.
How To Remove Hub Motor
1. Remove the two nuts on each side of the motor.
2. Remove brake adjustment nut and remove brake cable from brake hub.
3. Remove brake hub lock nut where it attaches to frame.
4. Remove axle lock plate by removing the #10 bolt on each side.
5. Follow the motor wires up under the rear fender, it will connect to quick disconnects and
unplug the cables.
6. Follow the chain up to the pedal sprocket and move the chain off of sprocket. Use the pedals
to turn until the chain is totally off of the sprocket. Then remove the sprocket off of wheel
sprocket.
7. Remove wheel motor from scooter.
How To Replace Controller
1. Remove the Battery Pack from the scooter and set aside until new controller is installed.
2. Open the seat and remove the four (4) seat barrel screws, two (2) near the Latch and two (2)
in Front.