X-TREME X-600, Руководство пользователя

Страница: 22 / 32

Page22
How To Replace Fuse
1) To replace the scooter fuse locate the spare 20amp glass fuse that came with the scooter.
2) Set scooter so that the rear wheel is not touching any surface.
3) Install the new fuse in the Fuse Holder which is located under the foot plate on the left
side of the scooter frame near the charger socket.
4) Confirm that it is securely installed.
5) Perform a test run with the rear wheel off of the ground.
6) If it does not run check the wires on the back side of the fuse socket for secure
connections. Check all other wire connections at this time.
How To Remove Rear Wheel
1) Block your scooters so the rear wheel is off the ground.
2) Remove the two 5mm allen screws from your rear brake caliper. Remove the caliper and
set aside.
3) Loosen the two 17mm axle nuts. Loosen the chain adjusters (they are attached to the axle
and the back of the frame) until you can move the wheel forward enough to remove the
chain. Slide the wheel out of the frame.
4) Reassemble in reverse order.
5) Tighten chain adjusters evenly keeping wheel straight with the frame. The chain should
be fairly tight with only slight up and down movement.
How To Install Seat Extension
1) To install your seat post extension you must remove the seat post from the extension.
2) Place some oil into the extension socket on your scooter.
3) Try to install the seat extension into the socket. If it still will not go into the socket, use a
rubber mallet and drive the seat extension into the socket until the cross pin in the extension
seats into the slot in the socket.
4) There is no pin or bolt for the seat extension. The cross hole in the seat socket is not
drilled through the plastic insert.