INSTALLATION
Transmitter Battery Unsealing
Before first use, gently pry open the rear cover of the transmitter and peel off the seal on the button cell.
Ensure correct polarity of the battery and close the battery compartment cover.
Transmitter Installation
To ensure sufficient wireless range, do not install the transmitter close to metals.
Adhesive Tape (recommended for water resistance)
1.
Clean all surfaces to be used for adhesion with rubbing alcohol.
2.
Apply the double-sided adhesive patch to the back of the transmitter.
3.
Remove the outer side of the patch, attach the transmitter to the desired location and press it firmly for
30 seconds.
Anchored Screws
1.
Gently pry open the rear cover of the transmitter and drill out the marked screw holes.
2.
Drill holes for the screws at the desired location and insert the anchors.
3.
Attach the rear cover to the wall by tightening it with the screws.
4.
To ensure resistance against water, seal the screw holes with silicone.
5.
Attach the transmitter onto the screwed-on back cover.
OPERATING INSTRUCTIONS
Pairing
1.
Plug the receiver into the power socket.
2.
Press and hold the volume button on the receiver for 3 seconds and the indicator will blink (press any
button on the receiver or wait for 60 seconds to exit pairing).
3.
Press the transmitter and the receiver will chime "ding" to indicate a successful pairing.
Pair Resetting
Hold the previous and next buttons for 5 seconds to clear the pairing between the receiver and all the
pre-paired push buttons (transmitters). "Ding" sounds on the receiver to signal that set pairs have been cleared.
Chime Selection
There are 56 chimes to choose from with this doorbell kit. Simply press the previous or next button repeatedly
to select one you prefer.
Volume Adjustment
There are 5 volume levels in total with the minimum volume level being silent. Press the volume button
repeatedly to cycle through the volume levels and set one to suit your needs.
TROUBLESHOOTING
Problem
Possible Cause
Solution