vipPAQ Hardware Installation Manual (Ed. 2c)
4
5 Mounting
Preparation
There needs to be two threaded holes suitable for M10 screws on both the left and
the right side of the press. If these 2 holes are not yet drilled, proceed as followed:
1. Mount the 2 vipPAQ distance holders at the outer limits of the mounting bar.
2. Mount the bushings at both vipPAQ mounting plates
3. Mount the 2 vipPAQ mounting plates at both sides of the mounting bar
4. Put this assembled system to the guide roller and mark the upper hole and the
outside edge of the mounting plates on the foreseen mounting area.
5. Take the assembled system from the guide roller
6. Verify the marked mounting plate position with the foils, delivered with the
vipPAQ system (see also figure 1 on next page) and mark the second hole on
both sides additionally.
7. Drill the 4 holes (2 on each side) for the M10 screws. You can either use the
screw with a nut or tab a thread.
