X-Rite Ci7500 Series, Руководство пользователя

Страница: 31 / 54

C i 7 X X 0 B E N C H T O P S P E C T R O P H O T O M E T E R
29
4. Align the sample holder base plate pins to the base plate mounting channel holes inside the
transmission area.
Position the base plate with the clamp mounting holes on the lens side. Be careful to get the
angle correct. Care should be taken to properly align this base plate so that the sample is
positioned towards the lens. It does not sit flush against the lens. Verify the angle is correct
by looking through the front aperture plate.
5. Attach the 25 mm sample stop to the base plate and 25 mm clamp to the carriage base with
the thumb screws.
The sample is held in position using a sample stop on the lens side of the sample, and a
spring loaded clamp on the side of the sample away from the lens.
Do not tighten the thumb screws until the sample has been positioned tight against this
opening.
6. Pull the clamp back and position the sample between the clamp and stop. You may want to
temporarily tighten the carriage base thumb screw to hold the clamp in place while
positioning the sample. Slowly release the sample clamp/carriage base to secure the sample.
Lens Side
Sphere Side
Clamp mounting holes
Base plate in direct
transmission position