2.2 Insert fastening B1 in the housing provided and press the visor against the shell
in line with fastening B2. This will activate the visor release button.
2.3 Slide the visor until the visor locks into place.
2.4 Repeat the same steps on the other side of the helmet.
3
VISOR ADJUSTMENT (FIG. 6)
The visor mechanism is equipped with a visor clearance take-up system that ensures
that the visor is pulled down and effectively against the window trim. This is why the
mechanism’s support has an upper and lower reference tooth.
The helmet is delivered with a correctly adjusted system.
When using the helmet, regularly check that the visor adheres perfectly and is in line
with the lip trim of the window trim when it is pulled down all the way. If this is not
the case, proceed as follows:
3.1 Disassemble the visor (see section 1) and check in which position of the upper
reference A1 and lower reference A2 teeth the mechanism is located.
3.2 Loosen the two screws B1 and B2 on the visor mechanism using a 2.5 mm Allen
wrench.
3.3 Lift the mechanism from its support and move it forward or backward according
to the adjustment to be made. Then lower the mechanism into its support so that
upper A1 lower A2 adjustment teeth are in the same position.
3.4 Tighten both screws B1 and B2.
3.5 Repeat the same steps on the other side of the helmet.
3.6 Mount the visor (see section 2)
3.7 Check contact between the visor and the trim.
WARNING!!!
-
After each assembly or disassembly procedure of the different parts, check that
the visor mechanism works properly by pulling the visor up and down; if neces-
sary, repeat the steps described above.
-
Do not remove the visor pulling up/down mechanisms from the shell.
•
WIND PROTECTOR (FIG. 7)
This accessory allows improved helmet performance under certain conditions of use.
The Wind Protector prevents unpleasant infiltrations of air under the chin.
See Fig. 7 for the assembly and disassembly.
•
RACING COMFORT - INNER COMFORT PADDING
To remove and/or reassemble the inner comfort padding, lift the VPS (Fig. 12A).
1
DISASSEMBLY OF THE CHEEK PADS
1.1 Open the chin strap (see specific instructions) and pull the front part of the left
cheek pad towards the inside of the helmet to release the 4 snap fasteners on
its back (Fig. 8A - Fig. 8B).
15
Содержание X-551
