X-Driven DRS1100, Инструкция по установке и эксплуатации

Страница: 6 / 15

UbONE
X-Driven
6
Installation Instructions
* Note
When a radio antenna is a glass-attaching type, it should
be attached with a distance from the GPS part as an
antenna can affect the GPS reception.
While pressing both left and right buttons on the side of
the body, rotate the camera lens to adjust its angle. The
line on the button should be set to a horizontal position
and be parallel to the road surface so that the camera lens
faces the front center of the windshield.
Insert the power cable into the power terminal on
the camera body, and ensure you use the power
cable enclosed in the product package.
After connecting the power cable into the cigarette
lighter jack of the vehicle, turn the ignition, and the
device will also turn on. Please check if the REC and
GPS LED are lighted on.
Horizontal
Horizontal
When GPS receiver is in the horizontal
position, reception rate is better.
* Note
After the initial operation begins, do not turn off the power for 2 – 3 minutes until
a continuous beeping sound is heard. This indicates that the SD card is formatted
and the PC installation program is being copied. If the power is turned off during
this operation, it may cause a malfunction. In this case, please contact the manu-
facturer or the store where you purchased the product.
Initial GPS reception time may vary depending on location.
Installing the device to the windshield of a vehicle