Page 8
Mode 2 Programming - Setting Scene Addresses
1)
Enter Mode 2.
See To Enter any Mode section.
2)
Press Scene Number.
A number between 1 and 16 representing scene of product.
3)
Press All-Lights-On key.
Product confirms Scene Number is entered.
4)
Transmit X-10 address.
Address will be the address of the scene number selected.
5)
Press All-Lights-On key.
The product stores new Scene Address into memory.
6)
Press All-Lights-On key 3 times.
The product is transferred out of programming
mode and into normal operation.
Mode 3 Programming - Setting Channel Enables
1)
Enter Mode 3.
See To Enter any Mode section.
2)
Press Scene Number.
A number between 1 and 16 representing scene of product.
3)
Press All-Lights-On key.
Product confirms Scene Number is entered.
4)
Press all applicable Channel Numbers.
A number representing which channel you
want to change. LM4s have channel numbers 1 through 4. MM2s have channel
numbers 1 and 2. SS1s have only channel number 1.
5)
Press the ON key or OFF key.
Pressing ON or OFF key will determine if the
channel will respond or not respond to the Scene Address.
6)
Press All-Lights-On key.
The product stores new Channel Enables into memory.
7)
Press All-Lights-On key 3 times.
The product is transferred out of programming
mode and into normal operation.
Mode 4 Programming - Setting Ramp Rates
1)
Enter Mode 4.
See To Enter any Mode section.
2)
Press Scene Number.
A number between 1 and 16 representing scene of product.
3)
Press All-Lights-On key.
Product confirms Scene Number is entered.
4)
Press Ramp Rate number.
A number between 1 and 16 representing the ramp rate
duration. The "1" key is an instant-on, "2" is 3 seconds, "3" is 6 seconds, "7" is 20
seconds, "12" is 7 minutes, "15" is 13 minutes, "16" is the security flashing mode.
5)
Press All-Lights-On key.
The product stores new Ramp Rate into memory.
6)
Press All-Lights-On key 3 times.
The product is transferred out of programming
mode and into normal operation.
