4
Chapter
Installing the Flash Module
This section provides information on how to install the flash kit in a Wyse Rx0L thin client.
Warning
Flash and RAM modules may be susceptible to damage by Electro-Static
Discharge (ESD). All industry-standard cautions should be followed to avoid
ESD. Before you remove or install a modules, touch any metal part of the
chassis and keep that contact with the chassis during the installation
process.
Removing the Existing Flash Module
To remove:
1.
Note where the connector of the flash module is located in Figure 4. Use Needle-nose
pliers to squeeze the plastic standoff lock as you rock the module back and forth to
remove module from the socket.
Figure 4 Removing the existing Flash module
Installing the New Flash Module
To install:
1.
Install the new module in the reverse order of removing the old flash module. Carefully
press the module onto the standoff lock and connector, making sure to lock it into
place.
