Installing the Option Kit
This chapter will describe the procedures for installing the 512MB
Flash Option kit in the model 9450XE, 9455XL or J400 Product
941GXL terminals.
Installing the Kit into the 9450XE Platform
Perform a proper shutdown of the terminal by ending your session and clicking the
buttons as they appear.
Unplug the power supply and remove all of the cables from the rear of the unit.
Remove the top cover from the 9450XE using the following steps:
Remove the top cover by pinching the top cover clamp and applying pressure
using the palm of your hand as shown in Figure 1 below.
Figure 1
Remove the IDE module retention bracket, if applicable, in Figure 2 or 3. Bracket may be
plastic or metal. In some cases a drop of hot glue is applied to the IDE connector.
Carefully cut this drop of glue if applicable.
Pinch the top cover
clamp with one hand
and apply pressure
with the palm of your
other hand in the
direction of the arrow.
