© Copyright 2018 WyreStorm Technologies |
WyreStorm.com
SW-0401-HDBT API | 180321-1319
3 of 12
North America: 844.280.WYRE (9973) | UK/EMEA: +44 (0) 1793 230 343
Email:
1.
Overview
The following document contains the Application Program Interface (API) commands to control the SW-0401-HDBT switcher via
serial and IP commands. Read this document in its entirety before starting any communication with the product.
1.1
Before You Begin
Verify that the following items are on hand and that all documentation is reviewed before continuing.
SW-0401-HDBT Switcher ......................................................................................................................................................................
Control System and Control System Documentation .......................................................................................................................
PC or Mac for Configuring Product and Telnet Communications ...................................................................................................
Network Connection with Network Passwords ..................................................................................................................................
Visit the Product Page on
to download firmware and additional product information .................................
2.
Wiring and Communication Configuration
WyreStorm recommends that all wiring for the installation is run and terminated prior to making connections to the switcher. Read
through this section in this entirety before running or terminating the wires to ensure proper operation and to avoid damaging
equipment.
2.1
RS-232 Connections
The following wiring diagrams show the pinouts for the switcher. While not shown, connect the TX (transmit) to RX (receive) pins at
the control system or PC side of the cable. Most control systems and computers are configured for Digital Terminal Equipment
(DTE) where pin 2 is RX and pin 3 is TX. This can vary from device to device, refer to the documentation for the connected device for
pin functionally to ensure that the connect connections can be made.
2.2
Serial Port Settings
Baud rate:
57600
Data Bits:
8bits
Parity:
None
Stop Bits:
1bit
Flow Control: None
Note:
This switcher is not controllable via Ethernet.
3.
Command Elements
•
Command Type: ASCII
•
Key Words are Case Sensitive
•
prm
= optional parameters
•
in = Video Input (HDMI/HDBaseT)
•
out = Video Output (HDMI/HDBaseT)
•
aout = Audio Output
•
Command termination requires <CR><LF>
Example: SET AUTOCEC_D
out
prm
<CR><LF>
